Product Description KONNWEI KW208 12V car battery tester is able to effectively analyze and read important car data such as voltage, internal resistance, cold cranking amp and AH capacity, battery health, and charge status. It provides accurate results, calculates the cold cranking capability of the battery and the aging extent. Test results display in both text and graphing, while the real-time battery voltage shows in a waveform. With an intelligent 2.4” Backlit screen and STM32 main chip, reading access is practical and rapid! Lifetime updates are supported by the KONNWEI BTlink app. As one of the most cost-effective products from KONNWEI, the KW208 can test all 12V 100-2000CCA batteries including regular flooded, AGM flat plate, AGM spiral, or gel batteries. Providing an overall analysis of the battery’s health and helping you know the battery status in advance before it dies. KW208 battery tester supports cranking and charging system tests as well as alternator and starter tests. KW208 12V Battery Load Tester gives you the basic battery parameters such as voltage, internal resistance, cold cranking amp and AH capacity, battery health, and charge status. Additionally, the battery cca tester will also give you professional advice on whether to replace or charge the battery. Thanks to the KW208’s powerful STM-32 chip, it provides more than 99.5% precise testing reports within milliseconds (testing results refer to US Midtronics), with a far quicker test time compared to other battery testers. KW208 Battery load analyzer allows you to test batteries both in-vehicle and out-of-vehicle and even test dead batteries. Just connect the tester’s clips to the battery – it will turn on, ready to test and analyze the battery. It’s that easy! KW208 is not only a great battery load tester that tests battery cranking & charging systems but also can test the alternator’s charging and starter’s cranking conditions. 1. Strong Capacity: Works on 12V batteries, battery ratings from 100 – 2200 CCA, including starter and alternator tester; 2. Test Multiple Battery Types: regular flooded, AGM flat plate, AGM spiral and gel; Test standards: CCA, BCI, CA, MCA, JIS, DIN, IEC, EN, SAE; 3. Support both in-vehicle and out-of-vehicle test, no need to remove the battery; 4. Battery Health Test, Cranking Test & Charging Test 5. Test result: SOH, SOC, CCA Value, CCA rating, voltage, internal resistance, etc; 6. Provide reliable results within seconds, accuracy up to 99.9%; display suggestion according to the testing results (Good, Recharge, Replace), detects bad cells directly; 7. Polarity reverses connection protection; 8. Supports 8 languages: English, Russian, French, Spanish, German, Italian, Portuguese, Dutch, etc. 9. Suitable for automobile factory, garage, auto battery manufacturer, and DIY enthusiasts, etc. Hardware specifications Display: Color TFT LCD Screen System Voltage:12 Volts Input Voltage Range:8V-16V Power Requirements: No internal batteries are required. Power on when hooked up during testing. Operating Temperature：0℃ – 50℃ Storage Temperature：-20℃ – 70℃ https://autosupply.co.za/wp-content/uploads/2021/08/Konnwei-KW208.mp4
